Tidy every cable on and under your desk with one print-and-go set: 11 desk-edge clips (one for each common desk thickness from 10 to 30 mm), 3 adhesive cable clips and 3 cable combs. Every part is a single piece that prints flat with no supports.

What's included (17 models, STL + 3MF)

• Desk-edge clips for 10, 12, 14, 16, 18, 19, 20, 22, 25, 28, 30 mm desks: push-on C-clamp with grip ridges and an open cable hook underneath (Ø12 mm, snap-in entry)
• Adhesive cable clips S / M / L for Ø4–9 mm cables, 24 × 14 mm flat face for double-sided tape
• Cable combs for 4, 6 and 8 cables (Ø5–6.4 mm, 9 mm pitch) to keep runs parallel
• A ready all-parts plate (3MF, 256 × 256 mm)

Print settings

• Print flat as supplied with no supports; every part is a 2.5D profile (0 % overhang)
• PETG recommended for the desk clips (spring-back); PLA fine for the rest
• 0.2 mm layers, 3–4 walls, 20–30 % infill

Fit

Clamp gap at the ridges = desk − 0.6 mm (0.3 mm preload per side), throat = desk + 1 mm, so the clip pushes on firmly and stays put. Measure your desk and pick the matching file.

Blender check (live Blender 5.2.1)

Fit tests (BVH triangle intersection)

• Desk clips: a slab of desk − 0.7 mm slides fully in with 0 intersections (11/11); the nominal desk thickness intersects only the grip ridges, the intended 0.3 mm preload per side.
• Cable hook: an 11.5 mm bundle sits in the hook with 0 intersections (11/11).
• Adhesive clips seat 4.4 / 6.4 / 9.0 mm cables with 0 intersections; combs seat 6.0 mm cables in every slot (0 intersections).
• Not yet physically test-printed.