Print a little winter village that glows on a shelf or windowsill. Each house holds a standard battery LED tealight, and the light shows through four-pane windows and peaked doors, with diamond-pattern gable openings above. Print the walls in a colour and the roofs and plinths in white and they read as snow-covered, with no multi-colour printer needed.
LED tealights only. Never put a real candle or any flame in or near a printed part.
The houses
- Gable Cottage: 72 x 66 mm plinth, 104 mm tall, door, eight windows, diamond gable lights and a chimney
- Tall Townhouse: 60 x 60 mm, 132 mm tall, three floors of windows
- Step-Gable Bakery: 70 x 70 mm, 114 mm tall, stepped front gable, shop window and chimney
- Long House: 104 x 62 mm, 89 mm tall, door and windows along the long side
- Three trees: stacked faceted cones 52, 72 and 96 mm tall
How it works
- Plinth: a 39.5 mm pocket with two finger notches holds a standard 38 mm LED tealight, and a low rim sits just inside the walls so the house stays put. Lift the house off to switch the light on.
- Walls: 1.6 mm, open at the bottom, printed upright.
- Roof: lifts off. Fins under the roof drop just inside the gable walls (0.3 mm clearance), so it sits square and can't slide off.
- Fit: standard (0.3 mm) and loose (0.5 mm) plinths for every house, plus small fit tests for the wall corner and the tealight pocket.
What's included (23 parts, each as STL and 3MF, in print orientation)
- 4 houses: walls, roof, standard plinth and loose plinth
- 3 trees
- 4 fit tests
- 4 ready plate 3MFs (one per house: plinth, walls and roof as separate objects on a 220 x 220 mm bed, so each part can take its own filament)
- The .blend file with every part in place
- A README with sizes, assembly and print settings
Print settings
- 0.4 mm nozzle, 0.2 mm layers, no supports, print as supplied, no scaling
- PLA or PETG; light colours glow best
- Walls print upright; roofs print the right way up (a small brim helps); trees and plinths print flat on their bases
- Tallest part 121 mm (Townhouse walls); every house plate fits a 220 x 220 mm bed
Please note
The LED tealights, floor and backdrop in the previews and 3D view are not included. Every fit was checked in software on the exported files. The houses have not yet been test-printed by us, which is why the fit tests are included.